Rev.081022
Page
7
of
19
FUS-20852000-0006
First Layer of Rope Performance
– 12,000 lb. winches
Line Pull
lb.(kg)
Line Speed
fpm(m/min)
Amp Draw
(DC12V)
Max. Pull Length
ft (m)
0(0)
27 (8.2)
59
82’ (25.0m)
3,000 (1,361)
10.6 (3.2)
146
20’ (6.1)
6,000 (2,722)
8.4 (2.6)
201
8’ (2.4)
9,000 (4,082)
6.9 (2.1)
260
3’ (1.0)
12,000 (5,443)
5.5 (1.7)
330
1’ (0.3)
First Layer of Rope Performance
– 10,000 lb. winches
Line Pull
lb.(kg)
Line Speed
fpm(m/min)
Amp Draw
(DC12V)
Max. Pull Length
ft (m)
0 (0)
29.8 (9.1)
57
82’ (25.0m)
2,000 (1,134)
12.7 (3.9)
132
21’ (6.4)
4,000 (2,268)
10.8 (3.3)
175
9’ (2.7)
6,000 (3,402)
9.2 (2.8)
211
4’ (1.2)
8,000 (3,629)
8.3 (2.5)
237
2’ (0.6)
10,000 (4,536)
7.0 (2.1)
292
1’ (0.3)
Assembly Instructions
⚠
WARNING
Read the entire Important Safety Information section at the beginning of this manual including all
text under subheadings before set up or use of this electric winch.
Mounting the Winch:
1.
The mounting plate must be rated to at least the winch
’s capacity. It must be flat and strong
enough to remain flat at maximum winch capacity. Winch must sit flat on winch mount with no
gaps under drum supports. It must have the hole pattern shown below.
2. Align the winch perpendicular to centerline of the vehicle at the desired location and mark the
locations of the winch base holes. Compare the dimensions of the marked holes.
3.
Before drilling, verify that the installation surface has no hidden components or structural pieces that
will be damaged.
NOTE:
This winch can generate extreme forces
.
Select a location that can withstand the rated
capacity without damage or weakening. Steel reinforcement plates may be required or a certified
welder may need to weld on additional bracing depending on the mounting location.
4.
Drill holes for the hardware at the marked locations.
5.
Install the winch using hardware described under the specifications table. Torque mounting bolts
to 30 ft.-lb. (41 Nm).
Summary of Contents for XP-12
Page 1: ...SAVE THESE INSTRUCTIONS...
