Würth 0701 330 0, Translation Of The Original Operating Instructions, Page: 17 / 188

17
Performance data
max. Ø mm / max. a × b 90° 45°
Ø
140 mm
125 mm (inox)
102 mm
a
b b
a
125 × 125 mm 75 × 100 mm
b
a
b
a
105 × 155 mm 75 × 100 mm
Replacing the saw blade (fig. V/
fig. VI)
■
Switch the machine off.
■
Pull the mains plug.
■
Release the wing bolt
[1]
.
■
Turn the small cover [2] back.
■
Lift up the vibration damper
[3]
and lock it
through lateral turning.
■
Press in the spindle lock
[4]
.
■
Release the screw with the Allen key.
■
Swing the mobile saw blade protection upwards.
■
Remove the saw blade carefully.
■
Push the new blade carefully onto the axle shaft.
When doing so, make sure the displayed turning
direction on the saw blade is in an anti-clockwise
direction. The saw blade must rotate in the direc -
tion indicated by the arrow on the protective
cover. Make sure the saw blade is free of grease.
■
Put in the external flange and the screw and
tighten them.
■
Turn the small cover [2] into the basic position.
■
Tighten the wing bolt
[1]
.
■
Set the vibration damper [3] in the basic position
by turning.
■
Release the spindle lock [4] and check whether
the saw blade can rotate freely.
Lubricating the saw blade guideways
■
Regularly spray the points at which the saw
blade comes into contact with the saw blade
guideways with lubricating oil spray.
Replacing the vibration damper
(fig. V)
■
If the vibration damper [3] has worn down to 1
mm, replace it.
Replacing carbon brushes
(fig. VII a+b)
If the carbon brushes
[2]
have been ground down
to approx. 6 mm, or sparks are forming, you need to
replace them. When doing so, always replace both
carbon brushes at the same time.
■
Pull the mains plug.
■
Remove the cover
[1]
.
■
Remove the worn down carbon brushes.
■
Insert the new carbon brushes and close the
cover once more.
Transport (fig. X)
■
Keep the locking bolts
[1]
pulled outwards.
■
Lower the handle to the lowest position.
■
Let the locking bolts snap in.
3
The machine is ready for transport.