ANI-1F3
16
ANI-1F3_V2.0.0_PI_2021-04_EN
Subject to technical changes
FRIGOLINK
Dismantling
1. Insert a flat-tip screwdriver in the openings in the fastening safety catches.
2. Pull the two fastening safety catches away from the housing until they are heard to click.
3. Swivel the bottom of the module gently away from the top-hat rail and towards yourself.
4. Lift the module upwards away from the top-hat rail.
1.6
Technical data
For details of input assignments, see: chapter 1.4.1 "Input circuit diagram" on page 6.
For details of output assignments, see: chapter 1.4.2 "Output circuit diagram" on page 9.
For details of sensor assignments, see: chapter "Analogue inputs S 1 - S 16" on page 8.
Power supply
230V~, +10% / -15%, 50Hz, max. 20VA
Display
Optional control panel with graphic display
1 x green/red LED, operating voltage: green, fault: red
4 x green LED, CAN bus data traffic (CAN Tx, CAN Rx)
Sensors
16 x DGF/TRK
C-BUS communication
3-wire CAN bus interface, shielded, galvanically isolated, screw ter-
minals 2.5mm
2
and RJ45 socket for communicating with system
devices
F-BUS communication
3-wire CAN bus interface, shielded, galvanically isolated, screw ter-
minals 2.5mm
2
and RJ45 socket for communication with field mod-
ules
Modbus communication
3-wire Modbus interface RS 485, shielded, galvanically isolated,
master, complete termination, screw terminals 2,5mm
2
Analogue inputs
5 x 4...20mA, 24V=power supply
2 x 0...10V=
Digital inputs
20 x floating for 230V~ (neutral conductor per input)
Analogue outputs
5 x 0...10V=, non-floating, max. load 10mA
Digital outputs
2 x mechanical relay 4(2)A@230V~ (changeover contact)
12 x mechanical relay 4(2)A@230V~ (normally open contact)
4 x semiconductor relay 4...60VA@230V~
Dimensions
(W x H x D) 270 x 80 x 165mm
Housing
Plastic
Fastening
Top-hat rail TH 35-15 or TH 35-7.5 (DIN EN 60715)
Ambient temperature
Operation: -20...+55°C, storage: -25...+70°C
Weight
About 1125g
CE conformity
-
2014/30/EU (EMC Directive)
-
2014/35/EU (Low Voltage Directive)
RoHS II
Valid from
Version 2.0.0
