Page | 45
iii.
Disconnect the existing UI Harness from the UI Board. Place the UI Board in secure place for reuse if it is
in good shape, replace UI Board if damaged.
See Figure 100.
c.
Cut off the damaged UI Harness as close to the back wall of the UI Board Housing as possible and discard it.
See Figure 101.
d.
Drill the UI Harness Access Hole:
i.
Mark 7.5inches from one edge of the Fridge on the bottom surface of the Overhang (below the plunger
the switch).
See Figure 102a.
ii.
Mark 1-inch from the front face of the Overhang and mark the drill location.
See Figure 102b.
Disconnect
UI Harness
Cut Off damaged
UI Harness
Figure 99: UI Board retaining screws removed.
Figure 100: UI Board to UI Harness connection.
Figure 101: UI Harness cut off point.
Summary of Contents for JoeTap NITCOM
Page 55: ...Page 55 Appendix C JoeTap NITCOM 110V Wiring Diagram ...
Page 56: ...Page 56 Appendix D John Guest Speed Fit Guide ...
Page 79: ...Page 79 Appendix J Fridge Functionality Maintenance and Troubleshooting Guide ...
Page 80: ...Page 80 ...