wtw Turb 555, Operating Manual

Page: 50 / 82

Operation Turb 555 / Turb 555 IR
50 ba41113e07 04/2009
Code function In the following menu, you can activate/deactivate the code
function and change the calibration or setup code (Code is
displayed in the upper display line).
Note
When the code function is activated, all measured values
output to the printer/PC are given the "QC" (Quality Control)
identifier, provided that the calibration interval has not ex-
pired (see section 4.6.2 O
UTPUT OF MEASURED VALUES
).
To select the code function, proceed as follows:
When you have switched on the code function, the menus to
change the two codes appear (steps 12 to 21). If you want
to keep the existing codes, press
6
instead of
1
. In this
case, the next setup menu (
p
) will appear immediately.
10 Press the
8
or
2
key to switch the code function on
or off.
11 Confirm your selection with
1
.