wtw Cond 7310, Operating Manual

Page: 17 / 60

Cond 7310 Operation
ba75933e04 06/2013
17
4.4.2 Measured value display (measuring mode)
In the measured value display, open the setting menus with the <F1> softkey.
The current functions of the softkeys are shown on the display.
 Use <F1> /[Menu] (short pressure) to open the menu for calibration and
measurement settings for the displayed measured parameter.
 Use <F1_> /[Menu] (long pressure (approx. 2 s) to open the Storage & config
menu with the sensor-independent settings.
Use the keys of the keypad to carry out further functions such as storage or cali-
bration (see section 4.1.1 K
EYPAD
, page 13). These functions are not available
in other operating situations.
4.4.3 Menus and dialogs (setting mode)
The menus for settings and dialogs in procedures contain further subelements.
 To select a subelement, use the <

><

> keys. The current selection is dis-
played with a frame.
 To make further settings, switch to the next higher menu level with
<F1> [Back].
 Use <M> to return to the measured value display.
Elements in menus
and dialogs
 Submenus
The name of the submenu is displayed at the upper edge of the frame. Sub-
menus are opened by confirming with
<ENTER> . Example:
 Settings
Settings are indicated by a colon. The current setting is displayed on the
right-hand side. The setting mode is opened with
<ENTER> . Subsequently,
the setting can be changed with <

><

> and <ENTER> . Example:
General
Interface
Clock
Service information
Reset
System
01.07.2011
08:00
Back