2-6
Unit Description
Network Port:
An RJ45 Ethernet port for connection to your 10Base-T or
100Base-T, TCP/IP network. Note that the RSM-8R4-DCM features a default IP
address (192.168.168.168). This allows you to connect to the unit without first
assigning an IP address. The Network Port also includes two LED indicators for
Link and Data Activity. For more information on port configuration, please refer to
Section 5.9.
Internal Modem Port:
For connection to your external phone line. For more
information on Modem Port configuration, please refer to Section 5.8.
DCD Indicator:
The Data Carrier Detect indicator.
Power Inlet:
An IEC320-C14 AC inlet which supplies power to the RSM-8R4-DCM's
control functions and switched power outlets. Also includes cable keeper
(not shown.)
Switched Outlets:
Four AC Outlets that can be switched On, Off or rebooted in
response to user commands:
•
RSM-8R4-1:
Four (4) each, NEMA 5-15R Outlets.
•
RSM-8R4-2:
Four (4) each, IEC320-C13 Outlets.
2.6. Front Panel Button Functions
The front panel buttons can be used to perform several functions described below:
Notes:
• Front Panel button functions can also be disabled via the System Parameters
menu, as described in Section 5.3.
• When the RSM-8R is reset to factory defaults, all user-defined configuration
parameters will be cleared and the default “super” user account will also be
restored.
• When the RSM-8R is reinitialized, all ports will be disconnected.
• During the reboot procedure, all port activity LEDs will flash once.
1.
Reboot Operating System - Keep User-Defined Parameters:
a) Press and hold the CLEAR or RESET button for five seconds, and then release.
b) The RSM-8R operating system will reboot ; all user-defined parameters will be
retained.
2.
Reboot Operating System - Reset All Parameters to Factory Defaults:
a) Simultaneously press both the SET or DEFAULT button and the CLEAR or
RESET button, hold them for five seconds, and then release them.
b) The RSM-8R operating system will reboot; all user-defined parameters will be
reset to factory default settings.