2-1
2. Unit Description
2.1. NPS-4HS15 Series - Front Panel
As shown in Figure 2.1, the NPS-4HS15 Series Front Panel includes the following
components:
1.
Network Port:
An RJ45 Ethernet port for connection to your 10/100/1000Base-T,
TCP/IP network. Note that the Network Port also includes two, small LED indicators
for Link and Data Activity. For more information on Network Port configuration,
please refer to the WTI Firmware Guide.
2.
SetUp Port:
An RJ45 RS232 serial port (DCE configuration) used for connection to
a local terminal or external modem, as described in Section 4.3. For a description
of the Setup Port interface, please refer to Appendix B.
3.
"ON" Indicator:
An LED that lights when power is applied to the NPS.
4.
"RDY" Indicator:
(Ready) Flashes if unit is ready to receive commands.
5.
Default Button:
Toggles outlets On/Off or resets unit to factory default parameters
as described in Section 2.11.
6.
Reset Button:
Reboots and/or resets the NPS to factory defaults as described in
7.
Output Status Indicators:
LEDs light when corresponding outlet is switched On.
NPS-4
Network
Power Switch
SETUP
PORT
DEFAULT
PLUG STATUS
RESET
ON RDY
ACT LINK
DEF RST
1
2
3
4
www.wti.com
1 2
3 4 5 6 7
Figure 2.1: NPS-4HS15 Series - Front Panel
