2-7
Unit Description
As shown in Figure 2.7, the NPS-8H20-ATS Series Front Panel includes the following
components:
1.
SetUp Port:
An RJ45 RS232 serial port (DCE configuration) used for connection to
a local terminal or external modem, as described in Section 4.3. For a description
of the Setup Port interface, please refer to Appendix B.
2.
Network Port:
An RJ45 Ethernet port for connection to your 10/100/1000Base-T,
TCP/IP network. Note that the Network Port also includes two, small LED indicators
for Link and Data Activity. For more information on Network Port configuration,
please refer to the WTI Firmware Guide.
3.
"ON" Indicator:
An LED that lights when power is applied to the NPS.
4.
"RDY" Indicator:
(Ready) Flashes if unit is ready to receive commands.
5.
Default Button:
Toggles outlets On/Off or resets unit to factory default parameters
as described in Section 2.11.
6.
Reset Button:
Reboots and/or resets the NPS to factory defaults as described in
7.
Output Status Indicators:
LEDs light when corresponding outlet is switched On.
2.7. NPS-8H20-ATS Series - Front Panel
www.wti.com
NPS-8-ATS
Transfer Power Control
SETUP
DEFAULT
OUTPUT STATUS
RESET
ON RDY
1
2
3
4
5
6
7
8
ACT
LINK
STATUS
1 2 3 4 5 6
7
Figure 2.7: NPS-8H20-ATS Series - Front Panel
