WSMP JR-138, Installation & Maintenance

Page: 4 / 10

4
Assembly Frame and Reflector
1. Face the flat surface of tank bracket outwards.
2. Insert tank bracket between top reflector bar and reflector frame, at the same time overlapping
holes. Fasten with the nuts and bolts provided.
3. Fasten other end of tank bracket to right and left upright supports.
4. 45º collector angle: fasten diagonal sidebars and bottom sidebars.
30º collector angle: fasten 4 diagonal sidebars and bottom sidebars.
5. Attach the 4 feet.
Storage tank assembly
1. Place tank onto tank bracket cradle, inserting protruding bolts into holes. Fasten with nuts.
2. Screw the air vent into place.
NOTE: Leave the nuts loose as some alignment/adjustment may be necessary after fitting tubes.
Unit Mounting Instructions
Mounting on the roof ridge
The assembled unit should be placed on the roof ridge, move the unit from south to north to adjust
the collector tilt angle, and ensures that the overflow pipe and inlet/outlet is vertical to the Horizon.
This is recommended only on roofs with slopes of between 21°and 40°.
Note: Remove diagonal sidebars if ridge cap impedes them. Ensure other attachments can
compensate for lack of diagonal sidebars.
Mounting on the roof slope
Determine roof angle.
Cut the right and left upright supports as specified in tab. 2.
Check tank is parallel with the ground, inlet/outlet pipes vertical.
Tab. 2 cutting upright supports instructions