wsm M6060, Workshop Manual

Page: 566 / 639

ELECTRICAL SYSTEM M6060, M7060, WSM
8-S57
Rotor
1. Remove the 4 screws and remove the bearing retainer.
2. Temporarily install the nut on the pulley screw, and remove the
rotor.
9Y1210828ELS0104US0
Brush
1. When the rotor is removed, the 2 brushes are found to stretch
out of the shaft hole.
9Y1210828ELS0105US0
Reassembling the Brush
1. Fit the brush with its sliding face in the clockwise direction when
viewed from front.
IMPORTANT
• Be sure to keep the 2 brushes deep in the brush holder.
Otherwise the rotor and the rear section can not be fitted
into position.
• Use a 4 mm hex. wrench to push the brushes into place.
• Using a pin-pointed (2 mm) punch, keep the brushes from
popping out.
2. Match the tally line of the front section with that of the rear
section.
3. Tighten the 4 screws, and draw out the pin-pointed punch out of
the brush holder.
9Y1210828ELS0106US0
(1) Marking
KiSC issued 08, 2013 A