wsm M6060, Workshop Manual

Page: 60 / 639

GENERAL M6060, M7060, WSM
G-37
Changing Front Differential Case Oil and Front Axle Case Oil
1. To drain the used oil, remove the drain plugs at the both front
axle gear cases and filling plugs, and drain the oil completely
into the oil pan.
2. After draining reinstall the drain plugs (1).
3. Remove the oil level check plugs (3).
4. Fill with the new oil up to the lower rim of check plug port on the
both front axle gear cases.
5. Finally fill with the new oil up to the lower rim of check plug port
on the front differential case. (See page G-13.)
6. After checking oil is visible through the openings of three check
plugs, reinstall filling plugs and check plugs.
9Y1210828GEG0042US0
[10] CHECK POINTS OF EVERY 1500 HOURS
Checking Fuel Injection Nozzle (Injection Pressure)
1. Refer to the Diagnosis Manual (9Y110-01990).
2. Use the Diagmaster Software.
3. Do the "Injection Stop" of active test on the Diagmaster
Software.
4. If the each injector is normal condition, the engine noise level
changes.
9Y1210828GEG0043US0
Checking and Cleaning EGR Cooler
• See page 1-S17.
9Y1210828GEG0044US0
Oil capacity
Front axle gear case
3.5 L
3.7 U.S.qts
3.1 Imp.qts
for each side
Front differential case
5.5 L
5.8 U.S.qts
4.8 Imp.qts
Front differential case
(SPAIN model)
5.0 L
5.3 U.S.qts
4.4 Imp.qts
(1) Drain Plug
(2) Filling Port
(3) Check Plug
(4) Filling Plug with Dipstick (A) Oil level is acceptable within this
range.
[A] SPAIN Model
KiSC issued 08, 2013 A