
7
1. Introduction
This mower is built to the highest standards in the industry. However, carelessness or operator error may
result in serious bodily injury or death. Accident and hazard prevention are dependent upon the awareness,
concern, wisdom, and proper training of the personnel involved in the operation, transport, maintenance,
and storage of the equipment. Make sure every operator is properly trained and thoroughly familiar with all
of the information in this manual before operating the equipment.
This machine is constructed only for mowing grass on lawns without obstacles such as stones, tree stumps
etc. The machine can also be used for other tasks when equipped with special accessory attachments;
Grass Gobbler, Rear Bagging System and JRCO attachments. All other types of uses are incorrect. The
manufacturer’s directions concerning operation, maintenance, and repairs must be carefully followed.
Lawn mowers and all power equipment can be potentially dangerous if used improperly. Safety requires
good judgment, careful use in accordance with these instructions and common sense.
The machine must only be operated, maintained a
nd repaired by persons familiar with the machine’s special
characteristics and who are also knowledgeable about the safety instructions. Use only approved repair
parts to maintain.
Accident prevention regulations, other general safety regulations, occupational safety rules, and traffic
regulations must be followed without fail.
Unauthorized modifications to the design of the machine will absolve the manufacturer from liability for any
resulting personal injury or property damage.
This machine is not intended for use in extreme environments, as a tow vehicle, on steep slopes greater
than 15 degrees or in an enclosed area without good ventilation.
1.1 Technical Data
Weight of overall machine
52” (132 cm) = 1039 lbs. (471 kg), 61” (155 cm) = 1121 lbs. (508 kg)
Machine dimensions
52
” (132 cm) = 67” (170 cm) L X 53” *65.5” (135 cm *166 cm) W
*
= Deflector down
61” (155 cm) = 69” (175 cm) L X 62” *74.5” (157 cm *189 cm) W
Speed
Fwd. 12.5 mph (20.1 km h), Rev. 5 mph (8 km h)
Power supply
12V DC
Summary of Contents for Stander ZK Series
