Wright Manufacturing Stander ZK Series, Instruction Manual, Page: 31 / 44

31
6.16 Lubrication
Grease with No. 2 general purpose lithium base or molybdenum base grease. Front caster wheels and
caster arm pivots are the only locations needing lubrication.

Set parking brake, stop the engine and remove the key.

Clean grease fittings with a rag.

Connect grease gun to fitting and pump until grease begins to ooze out
from the bearings.

Wipe off excess grease.

Do not use spray lube of any kind on choke
and/or throttle cables.

Service intervals:
First 8 hours
Every 25 hours
Also see Maintenance chart
6.17 Cleaning the Mower
The underside of the mower deck should be checked and cleaned twice daily and more often if the grass
being mowed is lush or wet
. The entire mower should be cleaned daily at the end of the work day.
Cleaning should be done with a leaf blower or low-pressure compressed air. Wash with water only when
necessary and do not use a pressure washer or nozzle as the water can enter bearings and electrical
connections causing an electrical short, rust and corrosion. When washing with water, avoid spraying near
the hydro cap and do so when the unit has cooled down. Washing a hot machine can cause various
unseen system damage. If water is used for cleaning, immediately dry it with a leaf blower or low-pressure
compressed air and run with blades engaged for approximately 10 minutes. Once the wash is complete,
always lubricate and grease all applicable areas.
7 Kawasaki Engine Manual / Maintenance
It is very important that all users of this unit
read and understand the Kawasaki Engine
Owner’s Manual. This manual contains;
safety awareness, emissions, maintenance
and warranty information that is critical for
the care of your Kawasaki engine. Below is
the periodic maintenance chart directly from
the Kawasaki Owner’s Manual, which is
included with the sale of the Stander ZK.
Remove dust cap,
disassemble and fill
cavity with grease
or remove bolt &
add install a grease
fitting to fill.