NANOLITER 2020/200704
World Precision Instruments
29
APPENDIX A: MICRO2T CONFIGURATIONS
Selecting System Options
The
System Options
screen gives you immediate access to basic parameters for your
operations. To access the
System Options
screen:
•
Select
System Options
from the main menu, or
•
From the
Pump Configuration
screen, press
Options
.
Fig. 49—The System Options screen allows you to set basic system parameters for operations. It
also lets you revert to the factory default setup.
NOTE
: Most parameters are stored in memory, even when the controller is powered off.
However, when the unit is powered on,
Remote Access
is always disabled, and the pump
drive motors are always enabled.
Disabling Sound Feedback
To disable all audio feedback from the
MICRO2T,
unselect the
Sound Enabled
check box.
To re-enable the controller sounds, select the
Sound Enabled
check box. Press
Back
to save
the setting and bring up the
Command
screen.
Enabling Remote (Computer) Access
Remote control of the
MICRO2T
is available through the USB port on the back of the
controller using a terminal access program on a computer. Before the controller can
receive commands from a computer, remote access must be enabled. By default, this is
disabled. To enable remote access:
1. Select the
Remote Access
check box.
2. Press
Back
to save the setting and bring up the
Main Menu
.
3. Press
Display All Channels
to bring the
Channel Data Display
. Remote commands are
only accepted while the unit is on this command screen.
Remote access is always disabled when the
MICRO2T
is powered up. If you power the
unit off, you will need to reset this parameter in order to operate with remote access. See
“Appendix B: MICRO2T Computer Control” on page 33.
