NANOLITER 2020/200704
World Precision Instruments
11
Fig. 15—Plug the NANOLITER2020 cable into one of the Output connection ports.
2. Connect the AC power supply unit to power port on the rear panel of the
MICRO2T
controller (Fig. 16).
Fig. 16—Connect the power supply to the power port on the controller.
NOTE
: The switchable power supply included with the controller automatically senses
input line voltage between 100 and 240 V and converts it to 12 V.
3. Connect the power cord to the power supply, and plug the AC power cord into a wall
outlet (Fig. 17).
Fig. 17—Connect the power cord to the power supply.
4. If the foot switch (WPI#
13142
, not included) is needed, plug it into the foot switch
port on the rear panel of the
MICRO2T
controller (Fig. 9).
5. Press the power button on the rear panel of the
MICRO2T
SMARTouch™ controller to
power on the unit. Verify that the LCD screen is illuminated.
IMPORTANT NOTE
: Before operating the
NANOLITER20202
pump (
300704
), you must
set the end of travel limits of the pump. See “Calibrating the MICRO2T System Travel Limits”
on page 15.
