HDBaseT Lite Transmitter/PoH
5
HDBaseT Cabling Requirements
For all HDBaseT Cabling, the EIA/TIA-568B crimp pattern must be used on
Category 6 or greater cable. In areas with large amounts of electromagnetic (EM) or
radio frequency (RF) interference, a shielded variety of Category 5e or greater cable
is recommended with shielded connectors on both ends of the selected cable.
3.2 Device Power
The HDBaseT Lite Transmitter supports two types of power input: PoH (Power over
HDBaseT) and rear panel input.
When using PoH, a compatible HDBaseT receiver can power the HDBaseT Lite
Transmitter by inserting power onto the twisted pair cable. When using a compatible
HDBaseT receiver, there is no need to use the rear panel power input.
If using a different receiver that does not supply power or the receiver requires remote
power, you must connect power to the rear power input. Using this method, the
included 12V DC 2A power supply must be used.
3.3 RS232 Connections
The HDBaseT Lite Transmitter can be controlled via RS232 by connecting to a
computer’s serial port or third party control system via the connected HDBaseT
receiver. The HDBaseT Lite Transmitter may also be directly controlled via the RS232
connection on the rear panel. Additionally, a third party device connected to the local
RS232 port may communicate directly to the display via RS232 through the HDBaseT
receiver.