Shading tape:
Used to blank the unrequired
UV
light around the
LCD
screen.
LCD screen:
Used to display the section pattern of the printed model and cooperate with the
UV
light
to cure the resin.
Notice:
❶
The
LCD
screen is extremely fragile
,
please be careful.
❷
If the tank leaks out and causes the resin to flow out and cured on the
LCD
screen
,
please carefully
remove the cured resin residue before the next printing.
❸
Make sure that there are no resin residues on the LCD screen to blank
UV
light.
❹
If the print failed
,
please clean the residual resin in the tank and aluminum plate in time to avoid
crushing the
LCD
screen when printing next time.
❺
Make sure the print platform is properly leveled when printing
,
so as to avoid damage to the
LCD
screen.
❻
Please ensure that the
FEP
film is close to the
LCD
screen to avoid affecting the print quality.
❼
Make sure that the black tape completely blank the unrequired
UV
light around the
LCD
screen.
Screw motor:
Used to drive the lifting cantilever move up and down.
Copper nut:
For working with screw motors.
Slide:
For linear motion guidance.
lifting cantilever:
Motor and slide control it's up and down during printing.
Notice:
❶
Do not block the rotation of the screw motor.
❷
Do not over-tighten the screws of the copper nut.
❸
Do not drop resin and other debris that interfere with its work on the slide and the screw.
❹
Please add grease to the screw
,
copper nut and slide in time to avoid excessive abrasion.
20
❺
Do not drop the resin on the apron. If it is accidentally dropped
,
please clean it in time.
Photosensitive resin:
Liquid light curing resin for printer use.
Notice:
❶
Do not touch the skin directly with the resin. Wear gloves when handling. If skin contact occurs
,
wash it with soapy water. If you feel unwell
,
please consult a doctor.
❷
The resin remaining after printing
,
if it would not be used for a long time
,
please keep it in cool and
dark place.
❸
Shake the resin evenly before use.
❹
Do not eat the printed model and the resin used for printing.
❺
Keep the resin out of reach of children and pets.
❻
Do not drop the resin onto any parts other than the tank and aluminum plate. If it is dropped
,
please clean it in time.
❼
Use of third-party color paste or other stains may result in printing failure or damage to the printer.
Working panel:
Panel for mounting components such as
LCD
screens and tank.
Hexagonal wrench:
Large hex wrench and small hex wrench for hex screws.
Trigger piece:
Used to trigger photoelectric switch.
Photoelectric switch:
Used to determine if the platform has reached the lowest point.
Notice:
❶
Do not block or blank the photoelectric switch
,
otherwise the photoelectric switch will not be
triggered.
❷
When leveling
,
please ensure that the trigger piece is inserted into the photoelectric switch groove.
❸
Do not drop the resin onto the working panel and photoelectric switch.
21
Important Definition
Important Definition
Summary of Contents for SparkMaker SLA
Page 2: ......
