Wow SparkMaker SLA, Operating Manual

Page: 10 / 58

Color
paste
Color principle：
CMYK is a color mode in which the four-color printing mode is used for color printing.
Color mixing principle plus black ink
,
a total of four colors mixed and superimposed to form
"full color printing".
The four standard colors are：
C=Cyan M=Magenta Y=Yellow K=key
Here K refers to the key
,
which is used for printing device calibration. K: It can also represent
Black
,
because printing is more often used in black. In addition
,
we also added a white color
paste.
C+M=Purple
M+Y=Orange
C+Y=Green
Method of operation：
Pour the resin into the paper cup first
,
then add a drop of color paste
to the cup
,
stir evenly
,
then add the resin and mix evenly.
Notice：
Adding a white color paste will make the color soft.
Adding black paste will make the color dignified.
Users can adjust different doses and ratios to call up richer colors.
The color paste addition ratio should be less than 1%
,
and the resin exposure time should be
appropriately increased after adding the color paste.
The resin after adding the color paste should be stirred evenly to prevent the color paste from
being precipitated.
16
Important Definition
Cover:
Protective cover to prevent external light and dust from affecting the resin in the tank.
Notice:
❶
Do not drop the resin on the cover. If it is accidentally dropped on it
,
please clean it in time.
❷
Do not put heavy objects on the cover to avoid crushing the cover.
Tank:
The container for storing resin during printing.
FEP membrane:
Located at the bottom of the tank for release demolding during printing
,
UV
light
can pass through its cured resin.
Notice:
❶ The
FEP
film at the bottom of the tank is easily damaged. Do not scratch it with a sharp object.
❷
After removing the tank
,
use a paper towel pad on the bottom of the tank to avoid damage to the
FEP film.
❸ Please clean the resin that has accidentally dropped on the outer wall of the tank and the screw hole
to avoid damage to the
LCD
screen.
❹
When installing the tank
,
please make sure that the FEP film is close to the LCD screen to avoid
affecting print.
Printing platform:
Parts for leveling and fixing aluminum plate.
Plate:
Aluminum alloy plate for sticking the model on the printing platform.
Notice:
❶
Make sure the print platform is fully inserted under the platform handle.
❷
Make sure the print platform is correctly leveled before printing to avoid damage to the
LCD
screen.
17
Color paste
Important Definition