Chain Saw
WG303E
11
OPERATION INTRODUCTION
INTENDED USE
The chain saw is intended for sawing of trees, tree
trunks, branches, wooden beams, planks, etc. Cuts can
be sawed with or across the grain. This product is not
suitable for sawing mineral materials.
ASSEMBLY
WARNING! Do not connect the chain saw to
mains before it is completely assembled.
Always use gloves when handling the chain.
CHAIN AND GUIDE BAR ASSEMBly
1. Unpack all parts carefully.
2. Place the chain saw on a solid, level surface.
3. Use only genuine WORx chains designed for
chainbar.
4. Slide the Chain (8) in the slot around the Guide bar
(7). Ensure the Chain is in correct running direction
by comparing it to the Chain Direction Symbol (14)
found on the saw body (See Fig. B). Ensure the Bar
Tensioning Plate (18) is facing outward (See Fig. A).
5. Fit the Chain onto the Drive Sprocket (13), so that the
Fastening Bar Bolt (17) and the two Bar Locating Tabs
(15) on the Bar Clamp (21) fit into the keyway of the
opening on the Guide Bar (7).
6. Check to see if all parts are seated properly (See Fig.
C1).
7. Fit the Chain Cover (11), ensure that the Chain Catch
(20) slides properly into the Chain Cover (See Fig.
C2).
18
8
7
A
13
14
15
17
B
C1
11
20
C2
