Worx Nitro WX843L, Instruction Manual

Page: 10 / 24

10 10
EN 20V Cordless Crown Stapler
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Intended Use
This tool is intended for nailing decoration of board line,
skirting line and wooden frame, etc.
WARNING: Do not point the nail gun to people or
animals. Always remove the nails and the
battery pack when not using the tool.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
Removing the battery pack See Fig. A1
Charging the battery pack See Fig. A2
Installing the battery pack See Fig. A3
ASSEMBLY
Installing the belt hook See Fig. B
Loading the brad nails/crown
staples
NOTE: Keep pressing the magazine
release button when opening or
closing the magazine.
WARNING: Keep the tool
pointed away from yourself
and others when loading nails.
Failure to do so could result in
possible serious personal injury.
See Fig. C1, C2
OPERATION
Drive depth adjustment
Rotate the depth adjustment knob
clockwise to increase the drive
force.
NOTE: Drive a test nail after each
adjustment until the desired depth
is set.
See Fig. D1
Drive force indicator See Fig. D2
Start the stapler
Press the contact against the
surface, then press the switch
trigger to start the machine.
See Fig. E
Install the wire and screen
accessory
Slide the accessory over the nose
of the nail gun until it fits into place
over the tab on each side of the
machine.
NOTE: Drive a test staple in a scrap
piece of the same material you will
be using to test for a desired drive
force.
NOTE: When not in use, the
accessory can be stored on the tool
in the “STORE” position.
See Fig. F
To use the screen and wire
application
See Fig. G1, G2
Remove the jammed nail
WARNING: Always remove
the battery pack first.
See Fig. H
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is
normal and will not damage your power tool.