Worx Nitro SWITCHDRIVER WX177L, Manual

Page: 13 / 32

20V Cordless Brushless SWITCHDRIVER 2.0 EN
13
USING THE LED LIGHT
WARNING: To turn on the light,
press the On/Off Switch and
make sure the Forward/Reverse Rotation
Control is on right/left position.
LED lighting increases visibility-great
for dark or enclosed area. LED is also a
battery capacity indicator. It will flash
when power gets low.
The tool and battery pack are equipped
with a protection system. When the LED
Light is quickly flashing and turn off, the
system will automatically cut off power
to the tool to extend battery life. The tool
will automatically stop during operation
if the tool and/or battery pack are placed
under one of the following conditions:
• Overloaded: The tool is operated
in a manner that causes it to draw an
abnormally high current. In this situation,
release the Trigger Switch on the tool
and stop the application that caused the
tool to become overloaded. Then pull the
Trigger Switch again to restart.
• Overheated: Under the condition
above, if the tool does not start, the Tool
and Battery Pack are overheated. In this
situation, let the Tool and Battery Pack
cool before pulling the Trigger Switch
again.
• Low battery voltage: The remaining
Battery capacity is too low and the tool
will not operate. In this situation, remove
and recharge the Battery Pack.
See Fig. H
SLEEP MODE AND REACTIVATION
When the Switchdriver is left without
any operation for 15 seconds, it will enter
sleep mode automatically.
By pressing / button or the on/
off switch, the Switchdriver will be
reactivated.
See Fig. I
6. TROUBLESHOOTING
1). THE DRILL DOES NOT TURN ON WHEN THE ON/
OFF SWITCH TRIGGER IS PULLED?
The Forward/Reverse Rotation Control, which is
above the trigger, is positioned in the lock function.
Unlock the Forward/Reverse Rotation Control by
putting it into the required rotation position. Push the
trigger and the drill will start to rotate.
2). REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Inappropriate charging time or leaving the Battery
Pack without using for a prolonged time will reduce
the Battery Pack capacity. This can be corrected
by charging & working with your drill several times.
Heavy working conditions such as driving large
screws into hard wood will use up the Battery
Pack energy faster than that in lighter working
conditions. Do not re-charge your Battery Pack below
0°C(32°F) and above 45°C (113°F) as this will affect
performance.
3).THE DRILL CHUCK DOES NOT ACCEPT A
DRILLING OR DRIVING BIT?
The SWITCHDRIVER is equipped with dual 1/4” hex
drive chucks and will only accept bits with a 1/4” hex
shank.
4). WHY DOES THE DRILL NOT WORK AFTER
ROTATING THE DUAL CHUCK?
The drill can work only when the Dual Chucks
Rotating Plate is in right position as shown in Fig. B2.
When the Dual Chucks Rotating Plate reaches proper
position, you can hear a “click” sound.
7. MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0
o
C-45
o
C (32°F-113°F).
The recommended ambient temperature range for
the charging system during charging is 0
o
C-40
o
C
(32°F-104°F).