28
Service Interval: 160hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Unhook seat latch and tilt seat up.
c) Lubricate switch actuator rod with spray type lubricant or light oil.
5.1.16. Lubricate brake handle pivot:
Service Interval: 160hrs.
a) Stop the engine, wait for all moving parts to stop, and remove key.
b) Lubricate bronze bushing on brake handle pivot with a spray type lubricant or light oil.
5.1.17 Lubricate brake rod bushings:
Service Interval: 160hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Unhook seat latch and tilt seat up.
c) Lubricate bronze bushing on each end of brake rod shafts with a spray type lubricant or a light oil.
One shaft is located under the console .The other is below and behind the seat.
5.1.18 Lubricate motion control bronze bushing:
Service Interval: 160hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Unhook seat latch and tilt seat up.
c) Lubricate bronze bushings on flange bearing securing the motion control arm shafts with a light oil or
a spray type lubricant.
5.1.19. Remove engine shrouds and clean cooling fins:
Service Interval: 80hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Remove cooling shroud clean-out covers from engine and clean cooling fins .Also clean dust, dirt and
oil from external surface of engine which can cause improper cooling.
c) Make sure cooling shroud clean-out covers or cooling shrouds are reinstalled. Operating the engine
without cooling shroud clean-out covers or cooling shrouds will cause engine damage due to
overheating.
5.1.20. Check spark plugs:
Service Interval: 160hrs.
Remove spark plugs, check condition and reset gaps, or replace with new plugs.
5.1.21.Change fuel filter:
Service Interval: As Required
A fuel filter is installed between the fuel tanks and the engine.
5.1.22. Change hydraulic system filter:
Service nterval: After First 250hrs.Then yearly thereafter
NOTE: Filter Oil: 25um.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Locate filter on the left side of the engine.
c) Carefully clean area around filter. It is important that no dirt or contamination enter hydraulic system.
d) Unscrew filter to remove and allow oil to drain from reservoir.
