
26
Run engine at one-third throttle,
Engaged
parking brake,
Engage
PTO and Raise Off seat (but do not
get off machine) Engine Must Stop after 1.5 second has elapsed.
Run engine at one-third throttle, with brake engaged, move levers in ----Engine must stop.
Again, run engine at one-third throttle,
brake Engaged
, and move
Left Motion Control Lever
In
-engine
Must Stop.
Repeat again moving the
Right Lever In
, then moving
Both Levers In-
Engine
Must Stop
whether
operator is
On Seat or Not.
NOTE: If machine does not pass any of these tests, do not operate. Contact your authorized
WORLDLAWN POWER EQUIPMENT SERVICE DEALER.
IMPORTANT
: It is essential that operator safety mechanisms be connected and in proper operating condition
prior to use for mowing.
5.1.7 Check rollover protections systems (roll bar)
Service Interval: Daily
a) Make sure latch pin and hair pin are fully installed and lanyard is in good condition.
5.1.8 Check for loose hardware.
Service Interval: Daily
a) Stop engine, wait for all moving parts to stop , and remove key.
b) Visually inspect machine for any loose hardware or any other possible problem. Tighten hardware or
correct the problem before operating.
5.1.9 Service air cleaner.
Service Interval: 50 hrs.
More often under severe conditions.
See Engine manual for additional informatio
n.
a) Stop engine, wait for all moving parts to stop, and remove the key.
b) Loosen retaining clips and remove air cleaner compartment cover.
c) Remove paper element. Check the condition of the paper element.
Replace if dirty, bent or damaged.
d)
DO NOT
wash or use pressurized air to clean paper element or inner element.
5.1.10 Change engine oil.
Service Interval: 100 hrs.
NOTE: Change oil and filter after first five (5)hrs. of operation.
a) Stop engine, wait for all moving parts to stop, and remove key.
b)Drain oil while engine is warm from operation.
c) Oil drain valve is located on left hand side of Kohler engine /on the right hand side of Kawasaki