13
2.11 TORQUE REQUIREMENTS
Bolt Location Torque
Cutter Housing Spindle Nut 190-197N-m
Blade Mounting Bolt 156-163N-m
Engine Deck/Front Frame Mount Bolts: 41-47 N-.m
Nylon Rollover Bolts: 54-61 N-m
Hydraulic Motor Mount Bolts 98-104N-m
Wheel Hub Slotted Nut 169 N-m
Rollover Protection System (Roll Bar) Mounting Bolts: 41-47 N-m
Drive Wheel Mount Bolts 170N-m
Engine Center Bolts 90 N-m
Pump Idler Arm Mounting Bolt 60 N-m
Engine Mounting Bolt 40 N-m
Pump Direct Connector 50 N-m
Pump 90
0
Connector 25 N-m
Left Motor Direct Connector 68 N-m
Right Motor 90
0
Connector 68 N-m
Filter Connector
（
R3/4
″
）
100 N-m
3. ASSEMBLY INSTRUCTIONS
3.1 UNCRATE MOWER
3.2 INSTALL ROLLER PROTECTION SYSTEM (ROLL BAR)
3.2.1 Disassemble roll bar from the crate.
Loosen Rollover protection system (roll bar) mounting bolts in the crate. Take the roll bar with its bolts
out.
3.2.2 Raise the rear of the unit and support it with jack stands or equivalent support.
POTENTIAL HAZARD
· Raising the rear of the unit for assembly relying solely on mechanical or hydraulic jacks could
be dangerous.
WHAT CAN HAPPEN
·The mechanical or hydraulic jacks may not be enough support or may malfunction allowing the
unit to fall, which could cause injury.
HOW TO AVOID THE HAZARD
· DO NOT rely solely on the mechanical or hydraulic jacks for support. Use adequate jack stands
or equivalent support.
