Operation
17
Stopping the washer
1. Release the trigger
13
. The high-pressure pump will stop
immediately.
2. Move the ON/OFF switch
5
to
OFF
.
3. Close the water tap for the water inlet.
4. Push the trigger until the pressure in the washer has been
released.
5. Lock the trigger by pushing downwards onto the safety lock
14
.
Adjusting the handle
The handle can be adjusted in two positions. The washer is
supplied with a lowered handle.
1. Press the button
8
for the height adjustment and pull the
handle
1
upwards until it locks into place. The washer can be
used and easily moved in this position.
2. Press the button again to lower the handle and push the handle
downwards until it locks into place.
Using a self-suctioning washer
Alternatively, you can also supply the high-pressure washer from
an open reservoir (water butt, industrial water tank).
Use a suction hose with a suitable suction basket to protect the
pump from foreign bodies. We recommend using a high-quality
suction hose made of reinforced material, the diameter of which
should be at least 13 mm and the maximum length 3 m. You can
achieve the best results by integrating a non-return valve and filter
in addition to the suction basket.
To connect the suction hose, please proceed as follows:
1. Place the high-pressure washer in close proximity to the water
source on a stable and level surface. Observe the maximum
recommended suction height of 0.5 m.
