3730 E. Southern Avenue, Phoenix, AZ 85040 USA
800-778-8779
Workhorseproducts.com
15
(A)
(B)
(B
(C)
(C)
(D)
(D)
(G
Print Head and Micro Adjustments
(D)
(C)
(B)
Using the X and Y Micro Adjusters: (D)
Always loosen the micro lockdown knobs (B)
before adjusting the micros.
To adjust the registration, turn
the X and Y micro adjusters (D). To move the screen left/right or up/down use the micro adjusters (D). To
move the screen up/down without moving it to the left/right, turn both micro adjusters (D) at the same time.
After adjustments are finished, tighten the micro lock down knobs (B), but don't over tighten.
Using the Side-to-Side Micro Adjuster: (A)
Always loosen the micro lock down knobs (B) before beginning the adjustment.
Turn the side-to-side micro
adjuster to move the screen side to side, to properly set it must be used in conjunction with the X and Y
micro adjusters (D). To utilize the full range of movement, both sets of adjusters must be used. Always center
the micros either after completing a job or beginning one because it will save a lot of movement.
Placing a Screen: (C)
To place a screen in the print head, loosen the two screen lockdown knobs (C) and raise the screen lockdown
clamp bar until the screen can fit in. Then push the screen all of the way to the back of the screen clamp.
After the screen is properly placed tighten the two screen lockdown knobs, but don’t over tighten.
Tip:
When using a back clamp printing press always measure the design height from the back of the screen,
to confirm the design will register even when using different size screens.
(A) Side-to-Side Micro Adjustment
(B) Micro Lockdown Knobs
(C) Screen Lockdown Knobs
(D) Y Micro Adjusters
(E) Screen Tilt Adjustment
(F) Off Contact Knob
F
D
D
A
B
B
E
C
C
