Print Head and Micro Adjustments
3730 E. Southern Avenue, Phoenix, AZ 85040 USA
800-778-8779
Workhorseproducts.com
14
Adjusting the Off Contact: (F)
The Odyssey is set at a standard off contact, however there will be instances that require adjusting it. To
readjust the off contact use knob (F) and use the 2 bolts (E) to adjust the tilt of the screen. When adjusting
the tilt you will need to loosen the bolts, make the adjustments and then tighten back down.
Tip:
This procedure will help set the off contact to be consistent and will require two 16" by 1" 10mm thick
strips of plastic (screen door window plastic). Place one strip on the pallet at the front of the screen and
one at the back of the screen. Adjust the screen until it makes contact with the plastic strips in the front
and the back. This procedure is helpful because it shows if the front end of the screen is parallel with the
back of the screen.
Adjusting the Screen Tilt: (E)
With the off contact strips on a pallet and a clean screen in the print head, lower the head to the pallet and
inspect the tilt is touching both the front and rear strip. If the front and rear off contact strips are not
touching the screen ends equally, you will need to adjust the screen tilt.
To start, loosen the two screen tilt bolts (E) with a 1/2” wrench. Press the front of the screen until it
makes contact with the plastic off contact strip. Next align the rear of the screen until it makes contact with
the rear plastic off contact strip. After the off contact is consistent, tighten the two screen tilt bolts (E).
Repeat as necessary on the other heads.
(A) Side-to-Side Micro Adjustment
(B) Micro Lockdown Knobs
(C) Screen Lockdown Knobs
(D) Y Micro Adjusters
(E) Screen Tilt Adjustment
(F) Off Contact Knob
F
D
D
A
B
B
E
C
C
