WORKHORSE CUSTOM CHASSIS
Service Manual
Automatic Transmission – Allison
2007 W Series
© 2006 Workhorse Custom Chassis — All Rights Reserved
SECTION
7.2
PAGE
525
2007 W Series Chassis
WSM082106
bolt; they are very similar. Tighten the top M8 thread
forming bolt to 20 to 28 pound-feet (27N•m to 38 N•m).
11. Tighten rear cover bolts that were loosely installed in
step 7.
12. Align the witness marks on the shift shaft adapter
with the witness marks on the actuator housing. For
Horizontally mounted Actuators use the single groove
witness mark on the Shift Shaft Adapter as shown in
the following graphic.
For Vertically mounted Actuators use the double
groove witness mark on the Shift Shaft Adapter as
shown the following graphic.
Place the shift shaft adapter into the center of the
actuator. Be sure that the Shift Shaft Adapter properly
engages the end of elector Shaft of the transmission.
