WORKHORSE CUSTOM CHASSIS
Service Manual
2007 W Series
SECTION
7.2
PAGE
402
Automatic Transmission – Allison
2007 W Series Chassis
© 2006 Workhorse Custom Chassis — All Rights Reserved
WSM082106
greater than 9.0 volts and less than 18 volts.
• HSD2 is commanded ON.
Conditions for Setting the DTC
DTC P2671 sets when the TCM detects greater than 6.0
volts at the HSD2 terminal prior to commanding HSD2
ON.
Action Taken When the DTC Sets
• The TCM illuminates the malfunction indicator lamp
(MIL).
• If the failure occurs while in a forward range, a shift to
1st, 3rd or 5th range is made.
• While diagnostic response is active, if the shift selector
is moved to NEUTRAL, the transmission will shift to
NEUTRAL. If the shift selector is moved to REVERSE,
the transmission will shift to REVERSE. If the shift
selector is moved to a forward range or to REVERSE
and the transmission is compromised by overspeeding or
direction change, the transmission will shift to NEUTRAL.
• DTC P2671 is stored in TCM history.
• Main modulation (MAIN MOD) is inhibited.
• The TCM freezes shift adapts.
• The TCM inhibits torque converter clutch (TCC)
engagement.
Conditions for Clearing the DTC
A scan tool can clear the code from TCM history. The
TCM automatically clears the DTC from TCM history if
the vehicle completes 40 warm-up cycles without failure.
Diagnostic Aids
• Inspect the wiring for poor electrical connections at the
TCM. Inspect for the following conditions:
– A bent terminal
– A backed-out terminal
– A damaged terminal
– Poor terminal tension
– A chafed wire
– A broken wire inside the insulation
• When diagnosing for an intermittent short or open,
massage the wiring harness while watching the test
equipment for a change.
• You may have to drive the vehicle in order to experience
a condition.
