5
5.1.5
Next / Last keys
Should the appointed channel level not be 0 level, press “Next” key, the next
channel level will be set to FL (FULL), while the levels of other channels will be set
to 0. On the contrary, press “Last” key in the same case, the previous channel
level will be set to FL, while other channel levels will be set to 0.
For example, input the command “20@90” on the LCD and press ”Enter” key
to confirm your operation, then press the “Next” key, the level of channel 21 will be
changed into FL, while other channel levels will be changed into 0.
5.1.6
Scroll keys
“
٧
” and “
٨
”
Press “
٧
” or “
٨
” keys , the LCD will display in four lines just like the following:
Ch001>80 00 00 FL 80
Ch006>00 00 FL 00 00
Ch011>00 00 00 00 00
Ch016>00 00 00 00 00
When scroll function works, all the 4 lines of display will show in channels until
once a key input again. The display will show back into 2 lines of channel and 2
lines for Command and Action. Go on to press “
٧
” or ”
٨
” keys to have a browse
of the display, and press any other key to exit this mode.
5.1.7
Changing Channel level patterns
Channel levels can be displayed in percent pattern (0%~100%) and in
decimal pattern (0~255). Press and hold the “view” key for about 5 seconds to
switch between these two patterns. The default pattern will be in Per(percent)
when the unit runs at its beginning.
5.1.8
To view the appointed Channel level
Input the relevant channel number and press “view” key, the corresponding
channel level will be displayed on the LCD.
For example, input “30 view” on the
LCD, you will see :
Ch030>66 FL 55 FL 55
Ch035>55 FL 55 FL 00
Cmd : 30
Act : Chan Change
That means the current level of Ch30 is 66 .
