WARNING:THIS APPLIANCE MUST BE EARTHED
RISK OF ELECTRIC SHOCK
DO NOT OPEN
IMPORTANT
The wires in the mains lead are coloured
in accordance with the following code:
GENERAL INSTALL ATION
DO NOT
run microphone cables near mains, data, telephone or 100V line cables.
DO NOT
run 100V line cables near data, telephone or other low voltage cables.
DO NOT
exceed 90% of the amplifiers output power when using 100V line (speech only).
DO NOT
exceed 70% of the amplifiers output power when using 100V line (high level
background music).
DO NOT
use re-entrant horn loudspeakers for background music unless the loudspeaker has
been specifically designed for this purpose.
AVOID
jointing the microphone cable, when this is unavoidable make sure a good
screened connector is used, e.g. XLR.
ALWAYS
use a balanced or floating low impedance microphone terminating into a balanced
input on long microphone cable runs.
ALWAYS
use a mains grade double insulated cable for the loudspeaker cable runs.
ENSURE
that all loudspeakers are in-phase.
ENSURE
that there are no short circuits on the loudspeaker line before connecting to the
amplifier.
Green and Yellow:
Earth
(E)
Blue:
Neutra (N)
Brown :
Live
(L)
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
markings identifying the terminals in your plug proceed as
follows:
The wire which is coloured green and yellow must be
connected to the terminal which is marked by the letter E
or by the safety earth symbol or coloured green and
yello w
. The wire which is coloured blue must be
connected to the terminal which is marked with the letter
N or coloured black. The wire which is coloured brown
must be connected to the terminal which is marked with
the letter L or coloured red.
If a 13 Amp (B.S.1363) plug or any other type of plug is
used,a 5 Amp fuse must be fitted either in the plug or at
the distribution board.
Tipo
Amplificador mezclador de megafonía con interfaz USB/SD
Modelo
PA 60 USB /R
Alimentación
AC 115V / 230V , 50 / 60Hz ± 10% Conmutable
Alimentación
Bateria
DC 24V (10% desviación max.)
90W
Potencia de Salida Max
:
Típica
:
60W
Salidas
Salidas de Altavoz: 8 ohms, 25V,70V,100V
Tape output: 350mV 4.7K
Ohms
Pre output: 1V , 600
Ohms
Entradas
Mic1/3: (1mV~200mV),250
Ohms balanceado con phantom seleccionable.
Aux1:500mV ,47K
Ohm
,desbalanceada
TEL : 0.1~1V,600
Ohm
, ajustable, balanceada
Power in:1V,47K
Ohm
,desbalanceada
Frecuencia de Respuesta
Mic1~Mic3: 60Hz ~ 15KHz ± 3dB
Aux1-2 : 50Hz ~ 20KHz ± 3dB
TEL : 100Hz ~ 15KHz ± 3dB
Distorsión Armónica
Menos de 1% a 1KHz, potencia nominal
Relación senal/ruido
Todos los controles de volumen en sentido antihorario 75 dB por debajo de la potencia tipica
Mic1 ~ 3
: 60dB por debajo de la potencia tipica
TEL :
70dB por debajo de la potencia tipica
:
Controles de Tono
Graves :
±
10 dB a 100Hz
Agudos:
±
10 dB a 10KHz
Controles
Mic1~Mic3 control de volumen
Aux1/Aux2 control de volumen
Master control de volumen
TEL control de nivel de entrada
Controles de Tono (Graves,Agudos)
Conmutador de sirena on/off
AC 115V / 230V Selector de red
Indicadores
Indicador de red (LED),Indicadores de nivel de salida (5 LEDS)
Consumo de potencia AC
170 W
Consumo de potencia DC
4A
Sirena
Sirena de dos tonos (Senal Ding/Dong precediendo una llamada)
-
Prioridad
Nivel de prioridad (Usando el conector Mic1~3, )
Tel / Emer
Mic1 Mic2 Mic3 Aux/C D
2 1 1 1
3
Dimensiones ( H
×
W
×
D )
88
×
430
×
260 mm
Peso
Aprox 8 kg.
Color
Negro
Opciones de montaje
Sobremesa o rack 19”
ESPECIFICACIONES TECNICAS
Aux2:500mV ,47K
Ohm
,desbalanceada
PA 60 USB /R User Manual/Manual de uso Pag 16
PA 60 USB /R User Manual/Manual de uso Pag 1
