18
Room thermostat
Comfort I – 6720810964 (2014/07)
6.5
rF 1 Pair with other devices
▶ Turn the knob to select
rF 1
and press to enter the function
▶ To
Pair
the devices, turn the knob to select
A
, pair this
programmer with the Room thermostat
▶ Press the knob to start the pairing process, the timer has to
be in the same mode,
page 14 Radio setting.
During the pairing process
0
flashes until the units
connected and then 1, 2 or 3 will be displayed flashing,
when the pairing is completed
A
is displayed.
Either wait 30 seconds and the display will revert to
displaying the current room temperature or to move to the
previous level, press the knob for more than three seconds.
To leave the menu and display current room temperature,
press the knob again until the three bars are displayed and
release the knob to display the current room temperature.
▶ To
Unpair
(disconnect) the units, turn the knob to select
d
▶ Press the knob to start the unpairing (disconnection), a 1,
2 or 3 will be displayed flashing, when the unpairing is
completed a flashing 0 will be displayed and when the
process is complete,
d
is displayed
▶ When the unit(s) have been unpaired or disconnected a
zero will be displayed indicating that no units are
connected.
Press the knob, for more than three seconds, to return to the
previous level,
rF 1
.
Press the knob until the three bars are displayed and release
the knob to return to the normal display i.e. the current room
temperature.
6.6
S 1 Software version
▶ Turn the knob to select
S 1
▶ Press the knob to enter the software version function
▶ The software version is displayed
▶ Press the knob for more than three seconds to return to the
previous level
6.7
S 2 RF signal strength
▶ Turn the knob to select
S 2
▶ Press the knob to enter the signal strength function
▶ The signal strength is displayed a number 0 to 10
[0]
no signal
[1-3]
weak signal
[4-6]
acceptable signal
[7-10]
very good signal
Press the knob, for more than three seconds, to return to the
previous level.
Press the knob until the three bars are displayed and release
the knob to return to normal display.
The Programmer/Receiver and Room
thermostat are delivered together and are
factory paired, they will automatically
connect when they are switched on.
If the units have to be paired, all units must be
in the pairing mode to be connected, refer to
Sections 5.2 Radio settings to put the
Programmer/Receiver into the pairing mode.
6720810964-12.1W
o
6720810964-08.1W
o
6720810964-09.1W
o
6720810964-13.1W
o
6720810964-14.1W
o
6720810964-15.1W
o