Worcester Greenstar 8000 Style GR8700iW 30 C, Installation And Maintenance Instructions Manual

Page: 77 / 80

Technical Specifications/Logs
77
Greenstar 8000 Style – 6720883864 (2019/02)
12.8 Gas boiler system commissioning checklist
This Commissioning checklist is to be completed in full by the competent person who commissioned the appliance as a means of demonstrating compliance
with the appropriate Building Regulations and then handed to the customer to keep for future reference.
Failure to install and commission according to the manufacturer’s instructions and complete this Benchmark Commissioning Checklist will invalidate the warranty. This
does not affect the customer’s statutory rights.
Customer name: Telephone number:
Address:
Boiler make and model
Boiler serial number:
Commissioned by (PRINT NAME): Gas Safe register number:
Company name: Telephone number:
Company address:
Commissioning date:
To be completed by the customer on receipt of a Building Regulations Compliance Certificate*
Building Regulations Notification Number (if applicable):
Controls: Tick the appropriate boxes
Time and temperature control to heating Room thermostat and programmer/timer

Programmable room thermostat

Load/Weather compensation

Optimum start control

Time and temperature control hot water Cylinder thermostat and programmer/timer

Combination boiler

Heating zone valves Fitted

Not required

Hot water zone valves Fitted

Not required

Thermostatic radiator valves Fitted

Not required

Automatic by-pass valve fitted to system Fitted

Not required

Boiler interlock Provided

All Systems
The system has been flushed and cleaned in accordance with BS7593 and boiler manufacturer’s instructions Yes

What system cleaner was used?
What inhibitor was used? Quantity litres
Has a primary water system filter been installed? Yes

No

The condensate drain has been installed in accordance with the manufacturer’s instructions and/or BS5546/BS6798 Yes

CENTRAL HEATING MODE measure and record
Gas rate m
3
/hr OR ft
3
/hr
Burner operating pressure (if applicable) mbar OR Gas inlet pressure mbar
Central heating temperatures Flow temperature °C Return temperature °C
COMBINATION BOILERS ONLY
Is the installation in a hard water area (above 200ppm)? Yes

No

If yes, and if required by the manufacturer, has a water scale reducer been fitted? Yes

No

What type of scale reducer has been fitted?
HOT WATER MODE measure and record
Gas rate m
3
/hr OR ft
3
/hr
Burner operating pressure (if applicable) mbar OR Gas inlet pressure mbar
Cold water inlet temperature °C
Hot water has been checked at all outlets Yes

Temperature °C
Water flow rate l/min
All INSTALLATIONS - Record the following:
Flue integrity check: Pass

At max. rate: CO ppm AND CO/CO
2
Ratio
Fail

At max. rate: (where possible) CO ppm AND CO/CO
2
Ratio
The heating and hot water system complies with the appropriate Building Regulations Yes

The boiler and associated products have been installed and commissioned in accordance with the manufacturer’s instructions Yes

The operation of the boiler and system controls have been demonstrated to and understood by the customer Yes

The manufacturer’s literature, including Benchmark Checklist and Service Record, has been explained and left with the customer Yes

Commissioning Engineer’s Signature
Customer’s Signature
(To confirm satisfactory demonstration and receipt of manufacturer’s literature)
* All installations in England and Wales must be notified to Local Authority Building Control (LABC) either directly or through
a Competent Persons Scheme. A Building Regulations Compliance Certificate will then be issued to the customer.
www.centralheating.co.uk