Wopa SA0061, User Manual

Page: 21 / 47

User manual
SA0061 Cattle Crush
Version: 09-07-18
Page 21 of 47
No.:
What to do
Action Outcome
1. Tip the nose wheel
downwards and
manoeuvre the crush
into the desired
position.
 Ensure that the crush is resting on the
nose wheel.
2. Remove the clamps

Remove the clamps and store them.
3. Connect the crush.
 See 4.2,5.1
4. Place the crush on
the lift.

First remove the folding gates from
the crush (Figure 5:1) and allow it to
rise under hydraulic pressure.
5. Remove the locking
pins from the shaft.

Remove the locking pins (Figure 5:2)
and place these in the location
provided.
6. Tilt the nose wheel
back up.
 Ensure that the nose wheel is folded
away during the work.
7. Use the hydraulic
system to place the
drawbar in its working
position.
 Use the left valve to place the drawbar
in its working position.
8. Place the protective
cover over the
drawbar.
 Place the protective cover over the
drawbar to cover the sharp edges.
(Figure 5:3)
9. Remove the
mudguards.
 Loosen the locking elements and lift
the mudguard out of the adapter.
10. Tilt the shaft.

Hold the locking pin in the torsion
shaft and operate the valve until the
wheels are folded up. (Figure 5:4)
4.2. Connect the machine.
NOTE

Check that the voltage specified on the machine plate matches the mains
supply.
 The machine must always be connected to an earthed socket to avoid the
risk of fire or electric shocks (the earth connection is coded green/yellow).
See also pg. 10
 The electrical installation including the sockets must be connected in
accordance with local regulations.

The power cable must always be free and nothing must be placed on top of
it.
 Replace the power cable immediately if it is damaged.