Adjusting the Brakes
The Woosh Zephyr comes equipped with disc brakes at both
the front and rear.
See the support section of our website at
www.wooshbikes.co.uk
for guides on how to adjust your
brakes.
If you are unsure about any of the adjustments that you may
need to make to your electric bike, take your bike along to
your local bike shop where they should be able to assist you.
Most of the components on our bikes (aside from the elec-
tronic parts) are the same as those found on regular bikes,
and so most bike shops should be happy to adjust these
parts (brakes, gears, chain, bottom bracket etc.) for you.
Controls and Indicators
The Zephyr CD electric bike comes with a throttle control to
allow you to vary the amount of assistance from the motor.
The throttle is located on the right side of the handlebars as
shown below. When the throttle is pulled fully, the motor will
provide the most assistance. The throttle feature is enabled/
disabled by the red button as indicated below.
Mounted on the handlebars is the control module. This is
used to turn the motor/bike on/off and also to increase/
decrease the amount of assistance given from the motor.
This module also indicates the current status of the battery.
To turn the bike on/off, press and hold the MODE button (the
middle button) as indicated above. To adjust the assistance,
use the UP/DOWN buttons. The other functions of the con-
trol module are covered in more depth later in the manual.
