20
Owner Service
MAN0884 (08/15/2011)
■
Before proceeding, read and follow all safety
rules.
To change the oil, follow this procedure, Figure 14:
1.
Suction out oil in gearbox through side plug using a
hand pump.
NOTE:
It is best to drain the oil when the gearbox
is warm to remove the most contaminants.
2.
Add 1.27 quart SAE 80W90 gear oil through side
plug. Use level hole (halfway up the backside of
gearbox) to check oil level. Add oil accordingly.
3.
Install and tighten plug.
Figure 14
. Gearbox Oil
Skid Shoes
The machine is equipped with skid shoes on the back
side of housing under the hitch frame to prevent wear-
ing the frame and provide depth control. They should
be checked occasionally for wear and replaced if
required.
■
Before proceeding, read and follow all safety
rules.
1.
Place a 4" x 4" block under each end of snow-
blower frame.
NOTE:
Block only high enough for the skid shoes
to clear ground.
2.
Lower snowblower to sit securely on blocks.
3.
Properly secure tractor and release all hydraulic
pressure.
4.
Loosen and remove skid shoe mounting bolts (2)
and nuts (3).
5.
Remove and inspect skid shoe (1).
6.
Adjust skid shoe (1) to provide correct depth of cut.
7.
Tighten mounting bolts (2) and nuts (3). Tighten to
specifications given on torque chart.
Figure 15
. Skid Shoe Adjustment
PTO Driveline Guard
The shield must turn freely on PTO shaft. Daily lubrica-
tion of both shield bearings and periodic cleaning will
ensure safe operation of the shield.
If shield is damaged or worn, replace components with
genuine Woods service parts.
Walterscheid Driveline
1.
Remove Phillips screw on driveline bell shield.
2.
Rotate bell shield until three reliefs align with white
plastic collar.
3.
Remove bell housing and shaft.
4.
Replace components as needed. Follow steps 1
through 3 in reverse.
NOTE:
In order to slide new bell over shaft guard,
place bell in water at 180° F or in sun to expand
bell temporarily.
Figure 16
. Walterscheid Driveline
WARNING
DP10
WARNING
1. Skid Shoe
2. 1/2 NC x 4 Cap Screw
3. 1/2 NC Flanged Lock Nut
DP7
