Assembly
33
MAN1078 (2/6/2014)
ASSEMBLY INSTRUCTIONS
DEALER SET-UP INSTRUCTIONS
Set-up of this cutter is the responsibility of the WOODS
dealer. It should be delivered to the owner completely
assembled, lubricated and adjusted for normal cutting
conditions.
The cutter is shipped nearly fully assembled. Recom-
mended torque values for hardware are located on
page 50.
Complete the check list on page 35 when assembly is
complete and cutter is delivered to the customer.
Before working underneath, carefully read Oper-
ator’s Manual instructions, disconnect driveline,
raise mower, securely block up all corners with
jackstands, and check stability. Secure blocking
prevents equipment from dropping due to hydrau-
lic leak down, hydraulic system failures, or
mechanical component failures.
Do not disconnect hydraulic lines until machine
is securely blocked or placed in lowest position
and system pressure is released by operating
valve levers.
Always wear relatively tight and belted clothing
to avoid entanglement in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
INSTALL DRIVELINE
1.
Remove driveline from wing.
2.
Remove 5/8” retaining bolt from driveline.
3.
Slide driveline yoke onto gearbox input shaft
aligning retaining bolt hole to groove in shaft.
4.
Reinstall 5/8” bolt and nut and torque to 110 ft-lbs.
5.
Remove driveline shipping brackets from wing.
6.
Replace bolts and nuts in skid shoe with carriage
bolts and nuts found in manual tube.
Figure 22
. Driveline Installation
WARNING
CAUTION
(Rev. 4/1/2021)
