23
result in damage to the product;
d) Please use the recommended sterilization procedures for sterilization.
It is not recommended to sterilize with other sterilization procedures
such as ethylene oxide, formaldehyde and low temperature plasma
sterilization. The manufacturer assumes no responsibility for the
procedures that have not been recommended. If you use the sterilization
procedures that have not been recommended, please adhere to related
effective standards and verify the suitability and effectiveness.
* Fractional pre-vacuum procedure = steam sterilization with repetitive
pre-vacuum.The procedure used here is to perform steam sterilization
through three pre-vacuums.
6.4.9 Storage
1.Store in a clean, dry, ventilated, non-corrosive atmosphere with a
relative humidity of 10% to 93%, an atmospheric pressure of 70KPa to
106KPa, and a temperature of -20 °C to +55 °C;
2. After sterilization,the product should be packaged in a medical
sterilization bag or a clean sealing container, and stored in a special
storage cabinet. The storage time should not exceed 7 days. If it is
exceeded, it should be reprocessed before use.
Notes:
a) The storage environment should be clean and must be disinfected
regularly;
b) Product storage must be batched and marked and recorded.
6.4.10 Transportation
1. Prevent excessive shock and vibration during transportation, and
handle with care;
2. It should not be mixed with dangerous goods during transportation.
3. Avoid exposure to sun or rain or snow during transportation.
7 Troubleshooting
Failure
Possible cause
Solutions
There is continuous
beep sounds after
starting the handpiece.
The continuous beep
sound is indicating that
the handpiece is under
reverse rotation state.
Stop the handpiece and
change the operating
mode to Continuous
Rotation Mode.
Summary of Contents for E-COM
Page 1: ...E COM Endo Motor INSTRUCTION MANUAL...
Page 29: ...ZMN SM 069 V1 7 20210427...
