6
Install First Tier Inclines and Risers
Pattern A
(see key on Fig. 4)
indicates first tier Inclines and Risers and is
composed of two 1"-2" Inclines and one 1" Riser. All 2" Risers are shown with
no pattern. Position Inclines and Risers centered over printed track plan. Pin
pieces in place with Foam Nails.
1. Place 2" end of first 1"-2" Incline
(Fig. 5)
at Point 1, working counter-
clockwise
(Fig. 4)
.
2. Place a 1" Riser at the 1" end of the first Incline
(Fig. 6)
.
3. Continue with the 1" end of another 1"-2" Incline ending at Point 2.
4. Complete first tier of track plan with 2" Risers
(Fig. 5a)
. Trim length if
necessary for proper fit
(Fig. 7)
.
5. When all pieces are pinned in place, apply glue along seams to secure
(Fig. 8)
.
Remove Foam Nails when glue is set.
6. To fill in gaps between Risers, cut pieces from 1/2" Foam Sheet to fit the four
small triangular areas as indicated
(Fig. 4)
.
Install Inclines and Risers
Fig. 7
Fig. 8
Fig. 4
Fig. 6
Track Plan
1" - 2"
Incline
1" Riser
Overpass Gap
1/2" Foam
to fill gaps
Pattern A
1"- 2" Incline
Fig. 5
2
1
ITEMS NEEDED
Woodland Scenics
❏
Foam Nails
❏
Low Temp Foam Glue Gun
❏
Low Temp Foam Glue Sticks
❏
1" - 2" Inclines
❏
1" and 2" Risers
❏
Scrap Pieces of 1/2" Foam Sheet
Household
❏
Hobby Knife or Foam Knife
❏
Ruler
❏
Sandpaper (120-grit)
❏
Track
