5
SETUP FOR DADO WIDTH
Clamp, or bolt, the Front & Back Fences of the Dado
Jig to the workbench. Always check that the Front Fence is
square to the Stationary Track before beginning.
Select the setup workpiece you want to cut the dado for.
Loosen the Adjustable Track and place the setup
workpiece on edge vertically between the sized
1/4” MDF Fences. Position the Adjustable
Track so the workpiece is sandwiched
snugly between the sized 1/4” MDF
Fences, tighten the two knobs
on the Adjustable Fence and
remove the setup workpiece.
Workpiece sets dado
width by indexing
between 1/4” Fences
Butt the two Work Stops against the back edge of
the workpiece to be dadoed and tighten the knobs.
These hold the workpiece against the Edge Fence.
Clamp the workpiece to the workbench, or clamp
stops to the workbench on either side of the
workpiece, to hold it’s position while dadoing.