USING THE HORIZONTAL ROUTER TABLE
The crank provides 1-3/8” of fine bit height adjustment.
By loosening the two ratchet handles on the crank support,
you can move the entire router plate/crank support assembly
up or down for a great range of coarse adjustment.
Make sure the two handles on the router plate are loosened
and the two handles on the crank support are tight before
attempting to turn the crank. Make sure you tighten
the router plate handles after all height adjustments.
Clamp or bolt the horizontal table to a workbench
before using. The horizontal table can be used for
mortising, edge routing, vertical panel bits, cutting
tenons, etc. For safety, we recommend the bit be kept
under the work/table during use.
For mortising, we recommend
our optional
6012 Mortising Table
.
©Copyright WOODHAVEN INC. 6/25/15
(800) 344-6657 or WWW.WOODHAVEN.COM
6000HD Parts List:
242
Miter Hold-In . . . . . . . . . . . . . . . . . . . . 1
240B
Hold-Down Featherboard . . . . . . . . . 1
HB030
1" Hex Bolt . . . . . . . . . . . . . . . . . . . . . . 2
WS002 1/4" Washer . . . . . . . . . . . . . . . . . . . . . . 2
5545
Hex Bolt Knob . . . . . . . . . . . . . . . . . . .2
Sto
ck
Fee
d
Dir
ect
ion
6000HD HOLD-ALL KIT:
Verify that you have all the parts listed.
Unplug the router and remove the guard from the
router plate of the Horizontal Router Table.
The 242 Miter Hold-In is designed to fit into the miter
slot in the Horizontal Router Table. Attach it to the table
using the hardware and following the directions that came
with it. Make sure the direction of the featherboard teeth
point in the same direction that the stock is being fed.
Insert the 1” hex bolts
(HB030A)
into the hex recess in the
hex bolt knob
(5545)
. Install a washer
(WS002)
on each
bolt. Insert the bolts through the slots in the Hold-Down
Featherboard
(240B)
and screw them in to the guard mounting
holes in the router plate. The featherboard teeth should
be pointing in the same direction the stock will be fed.
Insert the work in between the featherboards and
work surface. Apply pressure to the featherboards to
compress the fingers slightly against the work, then tighten
the knobs. As the work passes each finger it will spring
back and help prevent the work from kicking back.
24
0B
24
2
