INSTALL CRANK
HANDLE & ROUTER
Get the crank
handle
(6000C)
. There
are two assemblies
to this part - one has
a crank, nut, and
mounting bracket, the
other has a bolt and
both and mounting
bracket. Attach the bolt
assembly to the back
top of the router plate
with two 1/2” screws
(5770B)
thru the two
holes in its mounting
bracket, but leave
them loose for now.
Install the crank
assembly on the back
of the crank support
(6000B - the side with
the machined ends)
using two 1/2” screws
(5770B)
thru the two
holes in its mounting
bracket, but leave them
loose for now. From
the front of the support,
insert a washer
(WS002)
on each stud of the
ratchet handle
(5859)
,
insert the stud thru the
hole at each end and
start an oval nut
(5760B
- smooth side first)
on
the end of the studs.
Slide the support/
oval nuts onto the 24”
tracks until the nut
of the crank lines up
with the bolt on the
plate. Turn the crank to
screw the nut onto the
bolt approximately 1”,
then tighten the ratchet
handles on the crank
support and the four
1/2” screws
(5770B)
.
60
00
C
60
00
B
5770B x4
5859 x2
WS002 x2
5760B x2
