Woodbridge DV2500-E, Installation And Operating Instructions Manual

Page: 34 / 48

OPERATING FIREPLACE
FOR YOUR SAFETY
READ BEFORE
LIGHTING
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do Not try to
light the pilot by hand.
use any phone in your building.
• Immediately call your gas supplier from a neigh-
bor's phone. Follow the gas supplier's instruc-
tions.
•
If
you cannot reach your gas supplier, call the fire
department.
C. Main gas valve in this appliance is not serviceable
and does not have any control knobs or switches to
operate. Do not remove heat shields covering the
valve and electronic devices; do not try to repair or
modify the valve as it may result in a fire or explo-
sion. Call
a
qualified service technician if you have
any safety concerns.
D. Do not use this appliance if any part has been under
water. Immediately call
a
qualified service techni-
cian to inspect the appliance and to replace any part
of the control system and any gas control which has
been under water.
OPERATING
INSTRUCTIONS
1.
STOP! Read the safety information, starting on page
2. Remove
media
tray from the appliance (see
I
llustrated
parts
l
ist),
3. Turn off all electric power to the appliance. Unplug
DC adapter from the power outlet.
4. Do not attempt to light the pilot by hand.
5.
Lift
and remove heat shield covering electronic com-
ponents inside of the unit (see illustrated parts list).
If
you don't smell gas, go to the next step.
Note:
Before applying any power supply to the DFC
board, please verify
that
the electrical connections
illustrated parts list), or mounted in adjacent wall.
Make sure that the remote receiver switch is in
"REMOTE" (middle) position.
Initializing the System for the First Time
1.
Set the remote receiver switch to the OFF position.
WARNING: If you do not follow these
instructions exactly, a fire or explosion may
result causing property damage, personal
injury or loss of life.
REMOTE
5
. Turn main shutoff valve counterclockwise
t
o
ON position.
6
. Set remote receiver switch
to
OFF position.
7
. Wait
five
(5)
minutes to clear out any gas. Then
smell for gas, including near the floor.
If
you smell
gas, STOP! Follow
"
B" in the safety information.
9
. Connect the wire to the DC input plug at the unit.
1
0
. Locate remote receiver either inside the unit (see
B. BEFORE LIGHTING
:
smell all around the appli-
ance area for gas. Be sure to smell next to the floor
because some gas is heavier than
ai
r
and will settle
on the floor.
WHAT TO DO
IF
YOU SMELL GAS
:
• Do not try to light any appliance.
• Do not touch any electric
switch; do not
are i
n
accordance
to Wiring Diagram
.
8
.
Plug supplied DC adapter into
110V
power outlet.
1
1
.
Replace
access panel (i.e inner cover or optional media
tray
)
.
2
.
Make sure that fresh set of
AA batteries
are installed
into
the battery holder and verify the polarity indicated on
the
battery holder.
If necessary, c
onnect the battery
holder to the DFC's main wir ing harness.
OPERA TING INSTRUCTIONS
Figure
43
- Remote Receiver Switch in OFF Position
Figure
42a
w
Remote Receiver Switch in OFF Position
Fiqure
42b
- Remote Receiver Switch in REMOTE
Position
3 4