PG
13
OF
20
M0054.07 JULY 2019
Gas-Fired Tandoor CE
Installation and Operation Manual
LIGHTING INSTRUCTIONS
Plan view
Rear view
Temperature
Control Knob
Remove
Deflector Plate
before lighting.
Temperature
Control
Knob
Spark Igniter Button (Red)
Grease/
Debris Pan
Lid
Gas Control Knob
PILOT LIGHTING PROCEDURE
Tip:
It is helpful to have a second person available to look into chamber to verify pilot has lit�
1.
Turn the Temperature Control Knob (on top of unit) to the OFF position�
Remove Lid�
2.
Remove Deflector Plate from bottom of Tandoor�
3.
Turn the Gas Control Knob to the PILOT position �
4.
Push down and hold the Gas Control Knob for 1 minute�
Then press the Spark Igniter Button every 2 seconds until a pilot flame is established�
5.
Hold the Gas Control Knob down for one full minute after pilot flame is established�
6.
Release the Gas Control Knob –
the pilot flame should continue to burn
�
NOTE:
If the pilot flame does not remain lit:
Turn the Gas Control Knob to the OFF position ,
Wait 5 minutes, and then
Repeat the steps above�
7.
Replace Deflector Plate to the bottom of Tandoor�
8.
Once pilot is established, turn the Gas Control Knob (counterclockwise) from the PILOT to the ON position �
NOTE:
Gas will not flow to the main burner unless the Gas Control Knob is in the ON position�
9.
Follow
First Firing
or
Daily Operation
sections as appropriate�
Round & Square Tandoors:
Use the Temperature Control Knob on top of the Tandoor�
Barrel models:
Use the Temperature Control Knob on the Control Box at the front end of the Tandoor�
PILOT
OFF
ON
Spark
Igniter
Button
Gas
Control
Knob
Pilot
