PG
12
OF
20
M0054.07 JULY 2019
Tandoor CE Installation
and Operation Manual
LOWER FLASHING INSTALL (BARREL)
DO NOT
LOWER STRIP FLASHING UNTIL TANDOOR IS LOCATED IN ITS FINAL INSTALLED POSITION
DO NOT
REMOVE PROTECTIVE TAPE FROM BOTTOM OF TANDOOR UNTIL STRIP FLASHING IS LOWERED
Leveling the Tandoor
Position Tandoor in its final installed position�
With the Flashing still in the UP position, level
the Tandoor using the four adjustable feet�
Plumbing the Tandoor
If the gas connection is made below the Tandoor,
plumb before lowering the Flashing�
If the gas connection is not from below the Tandoor,
it will be necessary to notch the Flashing�
This should be done after the Flashing is lowered�
Lowering the Flashing
The unit ships with the Strip Flashing secured into
its “UP” position with a screw at each leg�
Installing the Flashing Filler
Remove screws and nuts from Flashing Filler�
Open Control Box�
Position the Filler so it spans the gap between ends
of the Lower Flashing�
Align the the holes in the Filler with the holes in the
Lower Flashing�
Fasten with the screws and nuts previously removed�
Screw holding
up flashing
Remove the screw from all 4 legs and lower the
Flashing evenly around the Tandoor, flat to the floor�
Center punch and pre-drill each Leg using the
existing hole in the Flashing as a guide�
Secure the flashing at each leg using the
self-drilling screw previously removed�
Center punch and
pre-drill using the
existing hole as a guide,
then fasten with screw
• •
•
•
Ü
• •
•
•
Ü
• •
•
•
Ü
