Wood-mizer LT15WB D17, Safety, Setup, Operation & Maintenance Manual, Page: 86 / 88

Sawmill Alignment
Blade Height Scale Adjustment
5
5-22 1510doc071918 Sawmill Alignment
See Figure 5-26. Loosen the top adjustment bolt, adjust the side support, and retighten the
bolt.Turn the adjustment bolt counterclockwise to tilt the top of the side support forward.
4. Repeat the vertical check for the remaining side supports and adjust as necessary.
Blade Height Scale Adjustment
After the entire sawmill has been aligned and all adjustments made, check that the blade height
scale indicates the true distance from the blade to the bed rails.
1. Move the saw carriage so the blade is positioned directly above one of the bed rails. Measure
from the bottom edge on a down-set tooth of the blade to the top of the bed rail, near the inner
blade guide assembly.
2. View the blade height scale with eyes level with the indicator. The scale should indicate the
actual distance from the blade to the bed rail. Adjust the indicator if necessary.
FIG. 5-26
Side Support
Adjustment Bolt
150039