Wood-mizer LT15WB D17, Safety, Setup, Operation & Maintenance Manual

Page: 55 / 88

Maintenance
Vertical Mast Rails
Maintenance doc071918 3-3
3
See Figure 3-1.
3.5 Vertical Mast Rails
WARNING! Before performing service near moving parts such as blades, pul-
leys, motors, belts and chains, first turn the key switch to the OFF (#0) position
and remove the key. Failure to follow this may result in serious injury or death.
Clean the vertical mast rails every 50 hours of operation.
CAUTION! Never use grease on the mast rails as it will collect sawdust.
3.6 Miscellaneous
WARNING! Before performing service near moving parts such as blades, pul-
leys, motors, belts and chains, first turn the key switch to the OFF (#0) position
and remove the key. Failure to follow this may result in serious injury or death.
1. Oil all chains with Dexron III ATF every fifty hours of operation.
CAUTION! Do not use chain lube. It causes sawdust buildup in chain links.
2. Grease the clamps and side support pivots with a NLGI No. 2 grade lithium grease every fifty
hours of operation.
3. Check the mill alignment every setup (
See Section SECTION 7
).
FIG. 3-1
150210-37
Track roller housing
Middle track cover
Track roller housing
Idle track wipers
Track wipers
50
50
50