Alignment
Blade Wheel Alignment
Alignment
15doc120709
6-3
6
wheel.
See Figure 6-3.
Use the vertical adjustment screws to adjust the drive-side blade wheel. To tilt the wheel ,
loosen the top adjustment screw one quarter turn. Loosen the jam nut on the bottom adjustment screw and
tighten the screw. Tighten the top and bottom jam nuts.
To tilt the wheel , loosen the bottom adjustment screw one quarter turn. Loosen the jam nut on the top
adjustment screw and tighten the screw. Tighten the top and bottom jam nuts.
5.
Recheck the vertical tilt of the drive-side blade wheel with the blade guide alignment tool. Readjust the blade
wheel as necessary until the front and rear of the tool are the same distance from the bed rail (within 1/16"
[1.5 mm]).
6.
Remove the tool from the blade and reattach it near the outer blade guide assembly.
7.
Measure from the tool to the bed rail at both ends of the tool. If the measurements at the front and rear ends
of the tool differ by more than 1/16" (1.5 mm), adjust the vertical tilt of the idle-side blade wheel.
See Figure 6-4.
Use the vertical adjustment screws to adjust the idle-side blade wheel. To tilt the wheel up,
loosen the bottom adjustment screw one quarter turn. Loosen the jam nut on the top adjustment screw and
tighten the screw. Tighten the top and bottom jam nuts.
To tilt the wheel down, loosen the top adjustment screw one quarter turn. Loosen the jam nut on the bottom
adjustment screw and tighten the screw. Tighten the top and bottom jam nuts.
FIG. 6-3
150075-1G
To tilt wheel up, tighten top
screw (loosening earlier
bottom screw). To tilt wheel
down, tighten bottom
screw (loosening earlier
top screw).
Alignment
Tool
Summary of Contents for LT15 M2 E11S
Page 1: ...Table of Contents Section Page Table of Contents SW 07doc1207091...
Page 2: ......
Page 6: ...6 15doc120709...