Setup & Operaton
Using Pattern Mode
1
1-25
60AS-R02doc032519
Setup & Operaton
[ symbol. Push the Down button to adjust the setting to 1 1/8". While pushing the Down
button, push the Up button to scroll faster. When you get close to 1 1/8", release both but-
tons. Push the Down button to fine tune the setting to exactly 1 1/8". Push the +/- Drop
button again to move the next pattern increment.
Accuset software rev. 4.05 and later
only:
The setting will automatically be copied from the previous setting to 1 1/8” for all the
remaining increments below.
(Accuset software rev. 3.03 - 3.05 only:
The setting will
automatically be copied from the previous setting to 1 1/8”. Repeat for the third pattern
increment.) Exit pattern edit mode by pushing the Manual button. Save the new pattern
setting by pushing the Up arrow button to enter Configuration Menu #1. Press the Save
Settings button to enter the Save Settings menu, then push the Save Now button. Push
the Pattern button to return to Pattern Mode and push Increment Selection button #4.
Accuset software rev. 4.05 and later only:
All of the pattern settings should now be 1
1/8”.
(Accuset software rev. 3.03 - 3.05 only:
The top three pattern settings should now
be 1 1/8” and the bottom three pattern settings should be 2”.)
Push the Manual Mode button and raise the saw head so the blade is positioned near the
top of the log. Push the Pattern button to return to Pattern Mode.
Push the up/down drum switch down and release. The saw head will automatically stop at
the first setting determined by the top pattern increment.
Make a cut, raise the saw head and return the carriage for the next cut. Push the up/down
drum switch down and release. The saw head will stop at the setting for the next cut.
Repeat this procedure down this face of the log as desired.
Turn the log as you normally would and push the Manual Mode button to place the
Accuset in Manual Mode.
Raise the saw head so the blade is positioned near the top of the log and push the Pat-
tern button to return to Pattern Mode. Make the cut, raise the saw head and return for the
next cut. Use the same procedure as described above to cut each side of the log until
done.
Auto-Bump Feature (Accuset software rev. 3.03b and later only):
The auto-bump fea-
ture is used to move the blade up a particular distance after each cut by simply bumping
the up/down drum switch in the up direction. This feature is available only when using pat-
tern button #1 (memory positions #1, #5, #9 & #13). Pattern buttons 2, 3 & 4 continue to
require manual raising of the blade if desired.
To use the auto-bump feature, program the desired pattern in any of the four memory
positions of button #1. The bump-up value used is the increment of AutoUp or AutoDown
that you last viewed. To set the bump-up value, place Accuset in AutoUp or AutoDown
mode and program an interval (example: 1/4”) into any of the 16 available memory posi-
tions. Return Accuset to Pattern Mode. Now when the drum switch is moved up and
released the blade will rise 1/4” and stop.
